Single-Phase Grounding Fault Location Scheme Based on Levenberg-Marquarat Algorithm

被引：0

作者：

Ma W. ^{[1
]}

Qiu Y. ^{[2
]}

Ding D. ^{[1
]}

Wu J. ^{[1
]}

Wang Y. ^{[3
]}

Lin S. ^{[1
]}

Hou W. ^{[1
]}

Zhang W. ^{[1
]}

机构：

[1] State Grid Hangzhou Power Supply Company, Hangzhou, 310009, Zhejiang Province

[2] State Grid Zhejiang Electric Power Company, Hangzhou, 310009, Zhejiang Province

[3] School of Electrical and Electronic Engineering, North China Electric Power University, Changping District, Beijing

来源：

Ma, Wei (jnyz-mawei@163.com) | 2018年 / Power System Technology Press卷 / 42期

关键词：

Fault location; Levenberg-Marquarat algorithm; One-terminal information; Single-phase grounding fault; Transition resistance;

D O I：

10.13335/j.1000-3673.pst.2017.2450

中图分类号：

学科分类号：

摘要：

In view that accuracy of one-terminal fault location method can be improved effectively for transmission line realized using data of multi-time sections, a single-phase grounding fault location scheme based on information from different sampling points is proposed in this paper. Firstly, the current distribution coefficient is regarded as imaginary, and the equations with real and imaginary parts are established based on the measured voltage and current at relaying point after the fault. Then, the overdetermined equations where fault location is unknown are built based on information from two consecutive sampling points. Finally, the fault location is calculated using Levenberg-Marquara algorithm. Simulation results based on PSCAD/EMTDC show that, the scheme can calculate the fault location accurately, not affected by fault phase, location of fault point, transition resistance, line load and system impedance. Compared with the fault location scheme not regarding current distribution coefficient as real, the proposed scheme provides higher accuracy and more stable performance. © 2018, Power System Technology Press. All right reserved.

引用

页码：3049 / 3054

页数：5

共 20 条

[1] Chen G., Wang D., Qiu Y., Et al., Challenges and development prospects of relay protection technology, Automation of Electric Power Systems, 41, 16, pp. 1-11, (2017)
[2] Zhang L., Wang D., Liu Y., Et al., Analysis on protective relaying and its operation conditions in 220 kV and above AC system of SGCC in past ten years, Power System Technology, 41, 5, pp. 1654-1659, (2017)
[3] Ma J., Ma W., Qiu Y., Et al., An adaptive distance protection scheme based on the voltage drop equation, IEEE Transactions on Power Delivery, 30, 4, pp. 1931-1940, (2015)
[4] Xu F., Dong X., Wang B., Et al., Combined single end fault location method of transmission line and its experiments, Electric Power Automation Equipment, 34, 4, pp. 37-42, (2014)
[5] Wang H., Sun Y., Xie M., Et al., Fault location algorithm of transmission lines taken advantage of fault resistance characteristic, Proceedings of the CSU-EPSA, 28, 3, (2016)
[6] Wang B., Ni J., Wang H., Et al., Single-end fault location for high impedance arc grounding fault in transmission line, Proceedings of the CSEE, 37, 5, pp. 1333-1340, (2017)
[7] Huang S., Cao K., Luo L., A method of impedance measurement to eliminate influence of transition resistance, Automation of Electric Power Systems, 37, 23, pp. 108-113, (2013)
[8] Dong X., Jiang Z., Yang X., Et al., Method to reduce influence of transition resistance based on single-end electric quantity, Electrotechnics Electric, 9, pp. 16-21, (2015)
[9] Wang B., Dong X., Bo Z., Et al., An impedance fault location algorithm for UHV long transmission lines with single-line-to-ground faults, Automation of Electric Power Systems, 32, 14, pp. 25-29, (2008)
[10] Ma J., Shi Y.X., Ma W., Et al., Location method for inter-line and grounded faults of double-circuit transmission lines based on distributed parameters, IEEE Transactions on Power Delivery, 30, 3, pp. 1307-1316, (2015)

← 1 2 →