Improved two-stage model predictive control for modular multilevel converters

被引:0
|
作者
Li T. [1 ]
Yao L. [1 ]
Zhang S. [2 ]
机构
[1] School of Mechanical Engineering, University of Shanghai for Science and Technology, Shanghai
[2] Xiping Power Supply Company, State Grid Henan Electric Power Company, Zhumadian
基金
中国国家自然科学基金;
关键词
additional redundant submodules; capacitor voltage equalization; improved two-stage model predictive control; modular multilevel converters; total harmonic distortion rate;
D O I
10.16081/j.epae.202308033
中图分类号
学科分类号
摘要
The application of model predictive control (MPC) based on finite control set(FCS) to modular multilevel converter (MMC) usually exposes problems such as complex calculation and serious distortion of output current at AC side. A dual-vector optimization harmonic current model predictive control strategy is proposed, which is an improved two-stage model predictive control, and can reduce the calculation amount of switch state combination and further optimize the output current at AC side. The MMC discrete mathematical model is derived, and a cost function without weight factors is constructed, and the duty cycle of the two-stage switching signal in the same period is redefined by calculating the minimum area surrounded by the actual current and the reference current, and an additional redundant sub-module method is introduced to eliminate the bridge arm circulating current, and then a loser tree multi-way merge sort algorithm to balance the capacitor voltage is proposed. A three-phase 23-level MMC simulation model is built on the MATLAB/Simulink platform to verify the effectiveness of the strategy. Compared with the two-stage model predictive control, the proposed control strategy is more accurate in tracking the output current of AC side and less in harmonic distortion rate. © 2024 Electric Power Automation Equipment Press. All rights reserved.
引用
收藏
页码:96 / 104
页数:8
相关论文
共 20 条
  • [1] RAO Hong, ZHOU Yuebin, LI Weiwei, Et al., Engineering application and development prospect of VSC-HVDC transmission technology, Automation of Electric Power Systems, 47, 1, pp. 1-11, (2023)
  • [2] DENG Weicheng, WANG Yunxin, XU Jianzhong, Et al., Coupling harmonic injection strategy for suppressing capacitor voltage fluctuation of MMC, Electric Power Automation Equipment, 42, 9, pp. 169-175, (2022)
  • [3] WANG Jin'an, XU Jianzhong, SOC balancing optimal control strategy amongst batteries in MMC-DES, Electric Power Automation Equipment, 43, 7, pp. 44-50, (2023)
  • [4] DING Ran, MEI Jun, ZHAO Jianfeng, Et al., Orthogonal virtual vector based circulating current reducing method for single-phase MMC system, Electric Power Automation Equipment, 38, 8, pp. 38-44, (2018)
  • [5] YUE Yufei, XU Qianming, MA Fujun, Et al., Dual-loop 2nd circulating current strategy based on estimated capacitor voltage fluctuation of sub-module for modular multilevel converter [J], Transactions of China Electrotechnical Society, 32, 10, pp. 20-32, (2017)
  • [6] WANG Guangzhu, SUN Changpeng, LIU Rufeng, Et al., Modular multilevel converter control strategy based on arm current control, Proceedings of the CSEE, 35, 2, pp. 458-464, (2015)
  • [7] LI Y, JONES E A, WANG F., The impact of voltage-balancing control on switching frequency of the modular multilevel converter[J], IEEE Transactions on Power Electronics, 31, 4, pp. 2829-2839, (2015)
  • [8] KONG Z, HUANG X, WANG Z, Et al., Active power decoupling for submodules of a modular multilevel converter[J], IEEE Transactions on Power Electronics, 33, 1, pp. 125-136, (2017)
  • [9] BEN-BRAHIM L, GASTLI A, TRABELSI M, Et al., Modular multilevel converter circulating current reduction using model predictive control [J], IEEE Transactions on Industrial Electronics, 63, 6, pp. 3857-3866, (2016)
  • [10] GUTIERREZ B, KWAK S S., Modular multilevel converters (MMCs) controlled by model predictive control with reduced calculation burden[J], IEEE Transactions on Power Electronics, 33, 11, pp. 9176-9187, (2018)