Research on simulation model of distributed parameter air source heat pump based on PID-bisection combination control algorithm

被引：0
|
作者：
Gong G. [1 ]
Li B. [1 ]
Zhou F. [2 ]
Huang X. [3 ]
机构：
[1] College of Civil Engineering, Hunan University, Changsha
[2] Shanghai Architectural Design and Research Institute Co., Ltd., Shanghai
[3] Changsha Real Estate(Group)Co., Ltd., Changsha
来源：
Taiyangneng Xuebao/Acta Energiae Solaris Sinica | 2022年 / 43卷 / 07期
关键词：
Air source heat pumps; Computer simulation; Distributed parameter method; PID- bisection combined control algorithm; Thermodynamics;
D O I：
10.19912/j.0254-0096.tynxb.2020-1129
中图分类号：
学科分类号：
摘要：
A two- stage compressed air source heat pump system thermodynamic model has been established in this paper by using distributed parameter method. Then we established a system- wide circulation distributed parameter model based on PID- binary combined control algorithm, and verified the accuracy of the model based on experimental data. The research results show that the average deviation between simulation data of COP and the experimental data of COP is 5.41% when the system model is operated in the two- stage compression heating mode. And the maximum deviation is under 15% in different operating modes. The deviations are all within the credible range, so the model can accurately reflect the law of system performance changing with external parameters. Comparing with the distributed parameter method model using only PID algorithm, the total iteration times of the model with using PIDbisection combined control algorithm are reduced by about 2.96 times. This model reduces computational effort greatly. The calculation speed of the model can be improved while ensuring the accuracy of the model. © 2022, Solar Energy Periodical Office Co., Ltd. All right reserved.
引用
收藏
页码：16 / 21
页数：5
相关论文
共 8 条
  • [1] LI Y X, YU J L., Theoretical analysis on optimal configurations of heat exchanger and compressor in a twostage compression air source heat pump system, Applied thermal engineering, 96, pp. 682-689, (2016)
  • [2] JIN X, WANG S G, ZHANG T F, Et al., Dynamic coupling model of compressor in variable capacity two-stage compression system, Chinese journal of mechanical engineering, 48, 10, pp. 145-152, (2012)
  • [3] JIANG S, WANG S G, WANG F., Simulation and optimization of heating performance of two-stage compressed air source heat pump, Chinese science and technology paper, 12, 1, pp. 24-31, (2017)
  • [4] TANG X M, JIN S M, XIE S P, Et al., Two-stage compressed air source heat pump water heater system simulation, Journal of Nanjing University of Technology (natural science edition), 32, 3, pp. 88-93, (2010)
  • [5] GONG G C, HUANG X W, ZHOU F Y., A distributed parameter method compressed air source heat pump model based on PID control algorithm, Science technology and engineering, 15, pp. 6066-6072, (2020)
  • [6] ZHANG C L., Principles and technology of refrigeration and air conditioning system simulation, pp. 91-95, (2013)
  • [7] VERA-GARCIA F, GARCIA-CASCALES J R, CORBERAN-SALVADOR J M, Et al., Assessment of condensation heat transfer correlations in the modelling of fin and tube heat exchangers, International journal of refrigeration, 30, 6, pp. 1018-1028, (2007)
  • [8] LI S S, WANG S G., Study on the influence of the intermediate injection state of the variable frequency twostage compressed air source heat pump system on the performance, Building science, 32, 8, pp. 56-63, (2016)
1