A Continuous Resistance Wire Probe Method for Determining the Critical Diameter and Thickness of Commercial Explosives

被引：0
|
作者：
Li K.-B. [1 ]
Li X.-J. [1 ,2 ]
Yan H.-H. [1 ]
Wang X.-H. [1 ]
Chen X. [1 ]
机构：
[1] Department of Engineering Mechanics, Dalian University of Technology, Dalian
[2] State Key Laboratory of Structural Analysis for Industrial Equipment, Dalian
来源：
Hanneng Cailiao/Chinese Journal of Energetic Materials | 2018年 / 26卷 / 07期
关键词：
Continuous pressure-conducted probe; Critical size; Diameter effect; Non-ideal detonation;
D O I：
10.11943/j.issn.1006-9941.2018.07.012
中图分类号：
学科分类号：
摘要：
To quantitatively determine the critical diameter and critical thickness of commercial explosives, a continuous resistance wire probe used to measure the velocity of detonation wave and shock wave was developed by ourselves. Using powdery ammonium nitrate/fuel oil (ANFO) as the test object, two kinds of charge forms of unconstrained cone-shaped charge and semi-constraint wedge-shaped charge were designed. The change curves in detonation velocity of the powdery ANFO under the two kinds of constrained conditions were measured and obtained by single experiment, then the corresponding critical diameter and critical thickness could be calculated. Results show that the critical size of powdery ANFO raises with the increase of explosive density. The average critical diameter of the explosive with the density of 0.67 g•cm-3 under unconstrained condition is 17.52 mm, and the critical thickness is 7.06 mm when the bottom steel plate is constrained. © 2018, Editorial Board of Chinese Journal of Energetic Materials. All right reserved.
引用
收藏
页码：620 / 625
页数：5
相关论文
共 13 条
  • [1] Харитон Ю.В., Вопросы теории ВВ, (1947)
  • [2] Wood W.W., Kirkwood J.G., Diameter Effect in Condensed Explosives. the Relation between Velocity and Radius of Curvature of the Detonation wave, The Journal of Chemical Physics, 22, 11, pp. 1920-1924, (1954)
  • [3] Sun C.-W., Wei Y.-Z., Zhou Z.-K., Applied Detonation Physics, pp. 216-239, (2000)
  • [4] Campbell A.W., Diameter effect and failure diameter of a TATB-based explosive, Propellants, Explosives, Pyrotechnics, 9, 6, pp. 183-187, (1984)
  • [5] Tan D.-W., Fang Q., Curvature effect for insensitive explosive at normal atmospheric temperature, Chinese Journal of Energetic Materials(Hanneng Cailiao), 13, 1, pp. 13-16, (2005)
  • [6] Bdzil J.B., Aslam T.D., Catanach R.A., Et al., DSD front models: nonideal explosive detonation in ANFO, (2002)
  • [7] Petel O.E., Mack D., Higgins A.J., Et al., Comparison of the detonation failure mechanism in homogeneous and heterogeneous explosives, Proc. 13th Symp, pp. 2-11, (2006)
  • [8] Lu C.-R., Liu Y.-C., Effect of RDX particle size on critical diameter, Journal-North China Institute of Technology, 25, 5, pp. 368-370, (2004)
  • [9] Wang J.-H., Liu Y.-C., Liu D.-C., Et al., Critical thickness of HNS, Chinese Journal of Energetic Materials(Hanneng Cailiao), 16, 2, pp. 146-148, (2008)
  • [10] Hu J.-H., Gao H.-W., Zhang L., Experimental of critical detonation diameter of emulsion explosive, Blasting, 32, 3, pp. 156-161, (2015)
12