Analysis on axial compressive bearing capacity of circular concrete-filled steel tubular stub columns with internal profiled steel under different steel ratio

被引：0

作者：

Mao W.-J. ^{[1
]}

Shi Y.-L. ^{[1
]}

Wang W.-D. ^{[1
]}

机构：

[1] Key Laboratory of Disaster Prevention and Mitigation in Civil Engineering of Gansu Province, Lanzhou University of Technology, Lanzhou, 730050, Gansu

来源：

Wang, Wen-Da (wangwd@lut.cn) | 1600年 / Tsinghua University卷 / 34期

关键词：

Axial compression; Concrete-filled steel tubular stub column with internal profiled steel; Confinement coefficient; Load-bearing capacity; Sectional steel ratio;

D O I：

10.6052/j.issn.1000-4750.2016.03.S004

中图分类号：

学科分类号：

摘要：

This paper presents a finite element (FE) model of concrete filled steel tubular (CFST) stub columns with internal profiled steel under axial compressive load using ABAQUS. The FE model was verified by experimental results in the literature. The mechanical behavior of CFST stub columns with internal profiled steel was analyzed by dividing the total sectional steel into steel tube and the internal profiled steel. The load distribution between different components of the column and the axial compressive stress-strain curves were calculated and compared with those of the CFST columns without internal profiled steel. The influence on load-bearing capacity of the steel ratios in the steel tube and internal steel under the same total steel ratio was investigated, and quantitative analyses were conducted by amplification factor IdexNc of load-bearing capacity and amplification index IdexNs of load-bearing capacity of CFST stub columns with internal profiled steel. The load-bearing capacity of CFST stub columns with internal profiled steel is lower than CFST columns without internal steel in general, and the ratio of steel tube is a factor that significantly influences the load-bearing capacity. The results show that the ratio of the outer steel tube should be no less than 60% of the total steel ratio. © 2017, Engineering Mechanics Press. All right reserved.

引用

页码：63 / 70

页数：7

共 13 条

[1] Ben K., Column curves of steel-concrete composite members, Journal of Constructional Steel Research, 39, 2, pp. 121-135, (1996)
[2] Wang Q., Zhao D., Guan P., Experimental study on the strength and ductility of steel tubular columns filled with steel-reinforced concrete, Engineering Structures, 26, 7, pp. 907-915, (2004)
[3] Geen T.P., Rassati G.A., Bidirectional tests on partially restrained composite beam-to-column connections, Journal of Structural Engineering, 132, 2, pp. 320-327, (2004)
[4] Zhu M., Wang Q., Feng X., Behavior and strength of square steel tube columns filled with steel-reinforced self-compacting high-strength concrete, 1st International Symposium on Design, Performance and Use of Self-Consolidating Concrete, pp. 167-173, (2005)
[5] Wang Q., Zhao D., Guan P., The load-bearing capacity of axially loaded circular steel tubular columns filled with steel-reinforced high-strength concrete, Engineering Mechanics, 20, 6, pp. 195-201, (2003)
[6] Zhou G., Luo C., Chen C., Et al., The structural design of the Haiyi hotel in Jiangmen, Guangdong Architecture Civil Engineering, 8, pp. 3-7, (2014)
[7] Wang Q., Zhao D., Guan P., Study on the mechanical properties of axially loaded steel tubular columns filled with steel-reinforced high-strength concrete, Journal of Building Structures, 24, 6, pp. 44-49, (2003)
[8] Zhu M., Wang Q., Feng X., Behavior of axially-loaded square steel tube short columns filled with steel-reinforced self-consolidating high-strength concrete, China Civil Engineering Journal, 39, 6, pp. 35-41, (2006)
[9] Yao G., Sun S., Li X., Research on hollow steel tube columns filled with steel-reinforced concrete subjected to axial-compressing, Progress in Steel Building Structures, 9, 6, pp. 26-32, (2007)
[10] Shi Y., Wang W., Wang Y., Mechanical behavior and parametric study of concrete-filled steel tubular stub columns with encased profiled steel under axial compression, Engineering Mechanics, 31, pp. 201-206, (2014)

← 1 2 →