Study on hysteresis behavior of two kinds of reinforced CHS X-joints

Ultra-low cycle fatigue loading tests were conducted on two reinforced CHS X-joints (external stiffening rings and plates) and an unreinforced joint to analyze their post-yield failure modes, fracture mechanisms, and hysteretic properties. The findings indicate that these three joints exhibit varying failure modes post-yield: the unreinforced joints fail primarily due to chord fracture at the weld; the ring-reinforced joints initially see ring fracture, followed by chord crack at the weld; while the plate-reinforced joints initially fail from chord fracture and subsequently develop cracks at the plate-chord interface. The reinforced joints display plumper hysteretic loops and higher ultimate bearing capacities than the unreinforced joint. Compared to X-1, the tensile and compressive ultimate bearing capacities of RX-1 have increased significantly by 56.9 % and 74.1 %, respectively. In comparison, those of TX-1 have increased moderately by 2.2 % and 67.6 %, respectively, albeit with a slight compromise in ductility. The cumulative energy dissipation of RX-1 and TX-1 has risen by 22.62 % and 131.99 %, respectively, compared to the unreinforced joint. Notably, the dissipated energy before cracking accounts for 16.50 %, 18.16 %, and 22.29 % of the cumulative energy dissipation for the three joints, respectively, highlighting the substantial contribution of crack propagation to energy dissipation under large deformations. The VUSDFLD subroutine based on Cyclic Void Growth Model (CVGM) is embedded into ABAQUS, this subroutine considers the initiation and propagation of joint cracks. Three finite element models with the same dimensions of the specimens were built to simulate the damage process of the joint. The results show that this method can accurately simulate such joints' cracking and crack growth behavior under cyclic axial load. The simulated hysteresis curve is in good agreement with the test curve.