Correction of the relative thermal deformation of dual star sensors for remote-sensing satellites

被引：0

作者：

Zhong J. ^{[1
]}

Guo S. ^{[1
]}

Wu J. ^{[1
]}

Pei J. ^{[1
]}

Jia Y. ^{[1
]}

机构：

[1] Shanghai Institute of Spaceflight Control Technology, Shanghai Key Laboratory of Spacecraft Intelligent Control Technology, Shanghai

来源：

Yaogan Xuebao/Journal of Remote Sensing | 2018年 / 22卷 / 02期

关键词：

Dual star sensors; Measurement precision; On-orbit correction; Remote sensing satellite; Thermal deformation;

D O I：

10.11834/jrs.20187302

中图分类号：

学科分类号：

摘要：

A high-accuracy satellite platform is required to obtain remote-sensing images that meet the requirements of high image quality and high resolution for payload imaging. In practical engineering applications, the thermal deformation error caused by the thermal environment of star sensors is always neglected. Therefore, relative thermal deformation between star sensors will negatively affect altitude determination by dual sensors. Thus, the thermal deformation error must be identified and corrected. In this study, the thermal deformation model is established on the basis of satellite remote-sensing data and then corrected. The parameters of the thermal deformation model established using the Fourier series reflect the real results of on-orbit thermal deformation, and the magnitudes of sinusoidal and cosine functions in the Fourier series are determined. Then, the estimated parameters are used to compensate for the output of star sensors. Comparing the altitude error of star sensors before and after correction revealed that measurement precision improved by 40% after correction. Results showed that the proposed method for thermal deformation correction can improve the measurement precision of star sensors and reduce the influence of slow-frequency error on the precisions of altitude determination. The proposed method has potential engineering applications for obtaining high-quality images. © 2018, Science Press. All right reserved.

引用

页码：197 / 202

页数：5

共 11 条

[1] Bian Z.Q., Cai C.S., Lyu W., Shen Y.L., High accuracy and high stability control technology of remote sensing satellite, Aerospace Shanghai, 31, 3, (2014)
[2] Deng Y.K., Zhao F.J., Wang Y., Brief analysis on the development and application of spaceborne SAR, Journal of Radars, 1, 1, pp. 1-10, (2012)
[3] Iwata T., Hoshino H., Yoshizawa T., Kawahara T., Precision attitude determination for the advanced land observing satellite (ALOS), (2007)
[4] Jiang F., Wang Z.S., Chen L.H., Wu Q.W., Guo L., Thermal design of star sensor assembly, Infrared and Laser Engineering, 43, 11, pp. 3740-3745, (2014)
[5] Jiang F., Wu Q.W., Wang Z.S., Miao J.Y., Guo L., Chen L.H., Yang X.W., Analysis and verification of structure stability and thermal stability of a bracket of star sensors, Infrared and Laser Engineering, 44, 11, pp. 3463-3468, (2015)
[6] Jorgensen J.L., Denver T., Betto M., Van Den Braembussche P., The PROBA satellite star tracker performance, Acta Astronautica, 56, 1-2, pp. 153-159, (2005)
[7] Jorgensen P.S., Jorgensen J.L., Denver T., Betto M., In-flight quality and accuracy of attitude measurements from the CHAMP advanced stellar compass, Acta Astronautica, 56, 1-2, pp. 181-186, (2005)
[8] Sun T., Xing F., You Z., Optical system error analysis of high accuracy star trackers, Acta Optica Sinica, 33, 3, (2013)
[9] Wang X.T., Li Y.C., Li X.Y., Mapping satellite-1 star sensor accuracy analysis, Journal of Remote Sensing, 16, pp. 90-93, (2012)
[10] Xiong K., Zong H., Tang L., On star sensor low frequency error in-orbit calibration method, Aerospace Control and Application, 40, 3, pp. 8-13, (2014)

← 1 2 →