Study on the Strain Rate Effect of Cement Mortar

被引：0
|
作者：
Yang Z.-W. [1 ]
Li J.-Z. [1 ]
Huang F.-L. [1 ]
机构：
[1] State Key Laboratory of Explosive Science and Technology, Beijing Institute of Technology, Beijing
来源：
Beijing Ligong Daxue Xuebao/Transaction of Beijing Institute of Technology | 2019年 / 39卷 / 06期
关键词：
Cement mortar; Dynamic strength; Length-diameter ratio; SHPB; Strain rate effect;
D O I：
10.15918/j.tbit1001-0645.2019.06.004
中图分类号：
学科分类号：
摘要：
To investigate the influence of strain rate on stress-strain relation and dynamic strength, uniaxial compression strength, elastic modulus and poisson's ratio of mortar were measured by quasi-static experiments. The one-dimensional stress experiment was carried out by using split Hopkinson pressure bar(SHPB), dynamic damage and stress-strain relation of the cement mortar with various length-diameter ratios at different loading rates were obtained, and the relation of DIF(dynamic strength increase factor) and strain rate was studied. The results show that dynamic compressive strength increases significantly with increasing strain rate. The DIF with thin specimens are smaller than those with thick specimens when diameters are the same, but length-diameter ratios are different. By comparing the recovered specimens, as the strain rate increases, the damage of the specimen increases, and the fragment size decreases. It is found that the failure energy increases with the growing of the strain rate. © 2019, Editorial Department of Transaction of Beijing Institute of Technology. All right reserved.
引用
收藏
页码：571 / 577
页数：6
相关论文
共 12 条
  • [1] Xue Z., Hu S., Dynamic behavior of cement mortar under confinement, Engineering Mechanics, 25, 12, pp. 184-190, (2008)
  • [2] Shi S., Wang L., Discussion on dynamic mechanicalbehaviors of cement mortar under quasi-one and one dimensional strain states, Chinese Journal of Rock Mechanics and Engineering, 20, 3, pp. 327-331, (2001)
  • [3] Shi S., Chen J., Li D., Et al., Study on the dynamic mechanical behavior of cement mortar under quasi-one dimensional strain state, Explosion & Shock Waves, 20, 4, pp. 326-332, (2000)
  • [4] Grote D.L., Park S.W., Zhou M., Dynamic behavior of concrete at high strain rates and pressures: I. Experimental characterization, International Journal of Impact Engineering, 25, 9, pp. 869-886, (2001)
  • [5] Hu S., Wang D., Dynamic constitutive relation of concrete under impact, Explosion & Shock Waves, 22, 3, pp. 242-246, (2002)
  • [6] Zhou J., Ge L., Effect of strain rate and water-to-cement ratio on compressive mechanical behavior of cement mortar, Journal of Central South University, 22, 3, pp. 1087-1095, (2015)
  • [7] JGJ/T_98-2010_Specification for mix proportion design of masonry mortar, (2010)
  • [8] JGJ/70-2009_Standard for test method of basic properties of construction mortar, (2009)
  • [9] Zou D., Liu T., Teng J., Et al., Strain rate effect on uniaxial compressive behaviour of concrete columns, Journal of Vibration & Shock, 31, 2, pp. 145-150, (2012)
  • [10] CEB-FIP Model Code 1990, (1993)
12