Distribution of Soil Compaction Stress during Contour Line Operation of Hillside Crawler Tractor

被引：0
|
作者：
Sun J. [1 ,2 ]
Chu H. [1 ,2 ]
Liu Q. [1 ,2 ]
Luo P. [1 ,2 ]
Yang F. [1 ,2 ]
Liu Z. [1 ,2 ]
机构：
[1] College of Mechanical and Electronic Engineering, Northwest A&F University, Shaanxi, Yangling
[2] Scientific Observing and Experimental Station of Agricultural Equipment for the Northern China, Ministry of Agriculture and Rural Affairs, Shaanxi, Yangling
来源：
Nongye Jixie Xuebao/Transactions of the Chinese Society for Agricultural Machinery | 2022年 / 53卷 / 07期
关键词：
compaction; contour line operation; hillside crawler tractor; sloping land; stress;
D O I：
10.6041/j.issn.1000-1298.2022.07.003
中图分类号：
学科分类号：
摘要：
Hillside crawler tractor (equipped with attitude adjustment mechanism) has good stability and obstacle-surmounting performance, and it is especially suitable for operation on hilly and mountainous slopes. However, due to the existence of the slope angle, the stress distribution under the tracks on both sides of the tractor is extremely uneven , which reduces the adhesion and passability of the tractor. Aiming at the problem that the internal stress distribution law of sloping soil is not clear when the hillside crawler tractor is driving and operating on the contour line slope, on the basis of in-depth analysis of the basic laws of the maximum grounding specific pressure and stress transfer of the crawler under sloping conditions, the EDEM-RecurDyn coupling method was used to carry out the simulation test, and the method of burying the soil pressure sensor was used to carry out the static test based on the small slope soil trench and the dynamic test on the slope field respectively. The static test explored the vertical stress distribution law of soil at different depths under the influence of moisture content, initial compactness, loading quality and slope angle. The variation law of the vertical, horizontal and lateral stresses of soil under the crawler with operating speed , state of the tractor body (leveled and unleveled) and the load when the tractor drive and rotary tillage on the contour line slope was studied by dynamic tests. And the influence of crawler tension on soil vertical and horizontal stress distribution was analyzed. The results showed that the vertical stress under the crawler presented a stress peak at the axis of each roller. The horizontal stress had a stress peak at the front and rear of each roller axis. Appropriately increasing the operating speed can reduce the peak value of vertical and horizontal stress in the soil. When the tractor speed was increased from 0. 5 km/h to 1. 5 km/h, the peak value of vertical stress was reduced by 35% , and the peak value of horizontal stress was reduced by 27%. The leveling of the tractor body can better improve the uniformity of vertical and horizontal stress distribution under the crawler on both sides. The vertical stress peaks on the low and high sides of the slope were respectively decreased by 13 % and increased by 18%, and the horizontal stress peaks on the low and high sides of the slope were respectively decreased by 28% and increased by 23%-When the crawler tension was reduced from 1. 2 X 104 kPa to 8. 0 X 103 kPa, the vertical and horizontal stress peaks were respectively decreased by 31 % and 22% , which showed that moderately reducing crawler tension reduced soil compaction. The research result can provide a theoretical basis for the optimization of relevant parameters of hillside crawler tractors , so as to improve the uniformity of soil stress distribution on slopes and alleviate the soil compaction. © 2022 Chinese Society of Agricultural Machinery. All rights reserved.
引用
收藏
页码：30 / 42
页数：12
相关论文
共 21 条
  • [1] CHI Renli, ZUO Shuzhen, XIA Ping, Et al., Effects of different level compaction on the physicochemical characteristics of soil and crop growth, Transactions of the CSAE, 17, 6, pp. 39-43, (2001)
  • [2] HE Tingfeng, DING Qishuo, ZHANG Wei, Et al., Optimization of analytical model and prediction of soil compaction stress based on stress transmission coefficient, Transactions of the Chinese Society for Agricultural Machinery, 51, 10, pp. 292-298, (2020)
  • [3] CHI Yuan, ZHANG Rongrong, REN Jie, Et al., Steering power ratio affected by soil sinkage with differential steering in tracked vehicle, Transactions of the CSAE, 32, 17, pp. 62-68, (2016)
  • [4] BLUNDEN B G, MCBRIDE R A, DANIEL H, Et al., Compaction of an earthy sand by rubber tracked and tired vehicles, Soil Research, 32, 5, pp. 1095-1108, (1994)
  • [5] KELLER T, TRAUTNER A, ARVIDSSON J., Stress distribution and soil displacement under a rubber-tracked and a wheeled tractor during ploughing, both on-land and within furrows [J], Soil and Tillage Research, 68, 1, pp. 39-47, (2002)
  • [6] LAMANDE M, GREVE M H, SCHJONNING P., Risk assessment of soil compaction in Europe-Rubber tracks or wheels on machinery, Catena, 167, 41, pp. 353-362, (2018)
  • [7] LAMANDE M, SCHJONNING P, TOGERSEN F A., Mechanical behaviour of an undisturbed soil subjected to loadings: effects of load and contact area, Soil and Tillage Research, 97, 1, pp. 91-106, (2007)
  • [8] DING Zhao, LI Yaoming, REN Lidong, Et al., Distribution uniformity of soil stress under compaction of tracked undercarriage, Transactions of the CSAE, 36, 9, pp. 52-58, (2020)
  • [9] ZHAO Zihan, MU Xihui, GUO Haoliang, Et al., Test and modeling on static ground pressure of rubber track conversion system, Transactions of the CSAE, 34, 3, pp. 72-79, (2018)
  • [10] LI Haozhan, WANG Hongyan, RUI Qiang, Et al., Calculation and testing verification of ground traction of tracked vehicles [J], Journal of Academy of Armored Force Engineering, 29, 1, pp. 36-40, (2015)
123