Preparation and characteristics of xanthan gum and MgO modified clay-cement based new spraying material of gas sealing

被引：0

作者：

Zhang H. ^{[1
]}

Hu X. ^{[1
,2
]}

Wang W. ^{[3
,4
]}

Liang Y. ^{[3
,4
]}

Wang Z. ^{[5
]}

Liu J. ^{[6
]}

Bai G. ^{[7
]}

Zhao Y. ^{[1
]}

Wu M. ^{[1
]}

机构：

[1] College of Safety and Environmental Engineering, Shandong University of Science and Technology, Qingdao

[2] State Key Laboratory of Mining Disaster Prevention and Control Co-founded by Shandong Province and the Ministry of Science and Technology, Shandong University of Science and Technology, Qingdao

[3] State Key Laboratory of Coal Mine Safety Technology, China Coal Technology and Engineering Group Shenyang Research Institute, Fushun

[4] China Coal Research Institute, Beijing 100013, China, Beijing

[5] Shandong Energy Group Company Limited, Jinan

[6] Zibo Mining Group Company Limited, Zibo

[7] Zibo Xianglong Measurement and Control Technology Company Limited, Zibo

来源：

Hu, Xiangming (Xiangming0727@163.com) | 1768年 / China Coal Society卷 / 46期

关键词：

Gas sealing mechanism; Microstructure; Pore analysis; Spraying material of gas sealing; XG-MgO modification;

D O I：

10.13225/j.cnki.jccs.HZ21.0181

中图分类号：

学科分类号：

摘要：

Aiming at the problems of poor strength, prone cracking, and low gas sealing efficiency of traditional clay-cement composite gas-sealing materials (CCC), a new type of clay-cement based spraying material of gas sealing (XM-CCC) modified by xanthan gum (XG) and magnesium oxide (MgO) was prepared. Through water separation proportion test, slurry time-varying and rheological tests, the best water-solid ratio of 0. 6 and the best clay content of 20% were determined. Through mechanical performance test and constrained expansion test, the optimal amount of XG 1. 5% and MgO 5% were determined. The compressive strength of XM-CCC (7 d) reaches 25. 33 MPa, the flexural strength reaches 9. 18 MPa, and the constrained expansion proportion of XMCCC (21 d) is stable at around 0. 028%. On this basis, combined with characterization methods, the formation mechanism and the gas sealing mechanism of XM-CCM were explored. The results show that the active functional groups such as hydroxyl group and carboxyl group in XG chelate with Ca2+ on the surface of slurry particles, and the clay particles are bound between the hydration products of cement particles, which improve the mechanical properties of XM-CCC. The hexagonal plate Mg(OH)2 crystals generated by MgO hydration support the pores of the system, which improves the shrinkage resistance of XM-CCC. In terms of pore structure, XG changes the pore structure of XM-CCC and reduces the average pore diameter. When Mg(OH)2 crystal fills the pores, the crystal growth pressure generated can resist the pore pressure, keep the matrix from cracking, and reduce the porosity at the same time. Under the combined action of XG and MgO, the gas permeability coefficient of XM-CCC is only 1. 47×10-12, which is much lower than that of surrounding rock. In economy of engineering application, XM-CCC has the advantages of convenient materials, simple production, low cost and simple and flexible construction technology. The field application results show that the XM-CCC coating is uniform, complete, and has good anti-cracking and sealing properties, so it has a good application prospect. © 2021, Editorial Office of Journal of China Coal Society. All right reserved.

引用

页码：1768 / 1780

页数：12

共 31 条

[1] ZHANG Ming, HU Yun, ZHU Fahua, Et al., A comparative study on the characteristics of energy consumption between china and the world's major economies, Natural Resource Economics of China, pp. 1-12, (2020)
[2] FENG Guorui, ZHANG Yujiang, QI Tingye, Et al., Status and research progress for residual coal mining in China, Journal of China Coal Society, 45, 1, pp. 151-159, (2020)
[3] XU Yu, LI Zijun, ZHAI Xiaowei, Et al., Potential coupled harzard zone of coal spontaneous combustion and gas in goaf under mining condition, Journal of China Coal Society, 44, S2, pp. 585-592, (2019)
[4] JIN Yongfei, GUO Jun, WEN Hu, Et al., Experimental study on the high temperature lean oxygen oxidation combustion characteristic parameters of coal spontaneous combustion, Journal of China Coal Society, 40, 3, pp. 596-602, (2015)
[5] ZHANG Junxiang, SONG Weibin, SUN Yuning, Et al., Experimental study and application of new polymer foam plugging material, Journal of China Coal Society, 43, S1, pp. 158-166, (2018)
[6] CAO Kai, Research on fire area management technology in fully mechanized top coal backout caving face, Coal Technology, 39, 11, pp. 109-111, (2020)
[7] ZHOU Fubao, LI Jinhai, LIU Yingke, Et al., A new spraying material of composite slurry and its property for air-isolation, Journal of China Coal Society, 35, 7, pp. 1155-1159, (2010)
[8] XU Bin, DONG Shuning, XU Lulu, Et al., Stability of cement-based grouting slurry and test of its bleeding law, Coal Geology and Exploration, 47, 5, pp. 24-31, (2019)
[9] XU Fu, FENG Yunxiao, Application analysis of polyurethane material in coal mine production, Chemical Enterprise Management, 33, pp. 44-45, (2020)
[10] DU Yunfeng, Study on spraying polyurethane foam materials for air leakage in gob roadway, China Coal, 43, 1, pp. 116-118, (2017)

← 1 2 3 4 →