Experimental study on construction parameters of collapsible loess foundation treated by vibrating rod compaction method

被引：0

作者：

Zeng B. ^{[1
,2
]}

Zhang D.-W. ^{[1
,2
]}

Liu S.-Y. ^{[1
,2
]}

Yang Y. ^{[3
]}

Zhang K. ^{[4
]}

Wang J.-L. ^{[4
]}

Du G.-Y. ^{[1
]}

机构：

[1] School of Transportation, Southeast University, Nanjing

[2] National Demonstration Center for Experimental Road and Traffic Engineering Education, Southeast University, Nanjing

[3] Jiangsu Shentai Construction Engineering Co., Ltd, Lianyungang

[4] China Railway Fifth Survey and Design Institute Group Co., Ltd., Beijing

来源：

Yantu Gongcheng Xuebao/Chinese Journal of Geotechnical Engineering | 2021年 / 43卷

关键词：

Collapsible loess; Foundation treatment; Jet pressure; Vibrating rod compaction method; Vibration frequency;

D O I：

10.11779/CJGE2021S2054

中图分类号：

学科分类号：

摘要：

In order to determine the construction parameters of the vibrating rod compaction method to treat the collapsible loess foundation, the self-developed vibrating rod compaction method equipment is used to carry out field tests on the collapsible loess foundation site to analyze the vibration frequency, drill bit form, jet pressure and influences of vibration point spacing on construction efficiency and treatment effect. The test results indicate that under the conditions of the site, when the vibration frequency is 16 Hz, the use of A-type combined drill bits can reduce the adhesion of the fin soil, and the construction rate and compaction effect are the best. The high-pressure jet of 0.8 MPa can assist the sinking of the vibrating rod. Under this pressure, the bearing capacity of the foundation soil increases significantly. Using the above parameters, the cone tip resistance and sidewall resistance of the collapsible loess foundation after treatment with different vibration point spacings are controlled to increase by about 200%~300%. The smaller the vibration point spacing, the more significant the reinforcement effect, but the smaller the vibration point spacing is easy cause bonding, 1.2~1.4 m is appropriate. The research results can provide technical reference for the further application of the vibrating rod compaction method in collapsible loess foundation. © 2021, Editorial Office of Chinese Journal of Geotechnical Engineering. All right reserved.

引用

页码：229 / 232

页数：3

共 10 条

[1] LIU Song-yu, CHENG Yuan, Resonance compaction method for highway ground improvement at liquefaction site, China Journal of Highway and Transport, 25, 6, pp. 24-29, (2012)
[2] LIU Song-yu, DU Guang-ying, MAO Zhong-liang, Et al., Field tests on improvement of collapsible loess by vibratory probe compaction method, Chinese Journal of Geotechnical Engineering, 42, 8, pp. 1377-1383, (2020)
[3] CHOW K Y., Deep Compaction of Sand Using Vibratory Probe, (1998)
[4] CHENG Yuan, HAN Jie, ZHU He-hua, Et al., Vibratory probe compaction effect on silty foundation treatment, China Journal of Highway and Transport, 32, 3, pp. 63-70, (2019)
[5] MASSARSCH K R, FELLENIUS B H., Vibratory compaction of coarse-grained soils, Canadian Geotechnical Journal, 39, 3, pp. 695-709, (2002)
[6] CHENG Yuan, Theory Study and Engineering Application on Vibratory Probe Compaction Method for Ground Improvement at Liquefaction Site, (2013)
[7] BROWN R E, GLENN A J., Vibroflotation and terra-probe comparison, Journal of the Geotechnical Engineering Division, 102, 10, pp. 1059-1072, (1976)
[8] WALLAYS M., Deep compaction by vertical and horizontal vibration, Geotechnical Engineering, 14, 1, pp. 55-78, (1983)
[9] JANES H W., Densification of sand for drydock by Terra-Probe, Journal of Soil Mechanics and Foundations Division, 99, 6, pp. 451-470, (1973)
[10] MASSARSCH K R, FELLENIUS B H., Deep Vibratory Compaction of Granular Soils, Elsevier Geo-Engineering Book Series, 3, pp. 539-561, (2005)

← 1 →