Performance characteristics for heating of gas engine-driven heat pump system with waste heat recovery at high ambient temperature

被引：0
|
作者：
Hu Y. [1 ,2 ]
Lyu J. [1 ,2 ]
Han T. [1 ,3 ]
Song W. [1 ]
Feng Z. [1 ,3 ]
机构：
[1] Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangdong, Guangzhou
[2] University of Chinese Academy of Sciences, Beijing
[3] ZKG Energy (Chongqing) Research Institute Co., Ltd., Chongqing
来源：
Huagong Jinzhan/Chemical Industry and Engineering Progress | 2022年 / 41卷 / 07期
关键词：
distributed energy resources; gas engine-driven heat pump (GHP); heat recovery; heating performance; primary energy ratio;
D O I：
10.16085/j.issn.1000-6613.2021-1869
中图分类号：
学科分类号：
摘要：
Gas engine-driven heat pump (GHP) is an advanced low-carbon, energy-saving and clean heating technology. In view of the limitations of the current commonly used in GHP system technology research, such as the lower limit of the ambient temperature of R134a refrigerant for heating mode was high and the energy efficiency of the piston compressor was low, an energy-efficient GHP experimental platform was built innovatively based on the use of R410A refrigerant and scroll compressors. The heating performance characteristics of the GHP system with waste heat recovery device at high ambient temperature were investigated. The changing laws of heating capacity (Qh), gas consumption power (Pgas), compressor power (Pcomp), primary energy ratio (PER) and coefficient of performance (COP) were obtained under the conditions of different outlet water temperature (tw,out), engine speed (Neng), inlet water flow rate (Gw)and whether the engine waste heat was recovered or not. The error analysis of the key performance parameters was carried out. The results illustrate that when tw,out increases from 41°C to 50°C, Qh, PER and COP decrease by 3.12%, 13.17% and 18.92%, respectively. The decline extent of PER is much smaller than that of COP. When Neng increases from 1200r/min to 1800r/min, the increase of Qh, Pgas and Pcomp are 51.03%, 43.98% and 55.37% respectively at tw,out of 50°C. Meanwhile, the increase of PER is 4.90% due to the influence of the increase of the effective thermal efficiency of engine. When Gw increases from 5.8m3/h to 11.5m3/h, the system performance parameters are not sensitive to the change of Gw. When the system undergoes waste heat recovery, Qh, PER and COP are all significantly increased, and they increase by 31.18%, 36.06% and 31.54% respectively when Neng is 1200r/min and tw,out is 41°C. The ratios of the recovered waste heat to the total heating capacity and total engine waste heat are 17.48%—24.54% and 44.16%~63.39% respectively. According to the error analysis, the errors of Qh, Pgas and PER are 3.29%, 1.00% and 3.44% respectively, indicating that the test results have high accuracy. © 2022 Chemical Industry Press. All rights reserved.
引用
收藏
页码：3553 / 3563
页数：10
相关论文
共 23 条
  • [1] SANCHEZ RAMOS J, GUERRERO DELGADO M, ALVAREZ DOMINGUEZ S, Et al., Gas engine heat pump system: experimental facility and thermal evaluation for 5 different units, Energy Conversion and Management, 199, (2019)
  • [2] LI Yu, HUANG Chong, HE Shihui, Et al., Study on simulation of natural gas engine-driven heat pump in heating conditions, Fluid Machinery, 36, 5, pp. 63-67, (2008)
  • [3] YANG Z, CHENG H, WU X, Et al., Research on improving energy efficiency and the annual distributing structure in electricity and gas consumption by extending use of GEHP, Energy Policy, 39, 9, pp. 5192-5202, (2011)
  • [4] ELGENDY E, SCHMIDT J, KHALIL A, Et al., Modelling and validation of a gas engine heat pump working with R410A for cooling applications, Applied Energy, 88, 12, pp. 4980-4988, (2011)
  • [5] YANG Zhao, GAO Yide, ZHANG Qiang, Et al., Performance analysis of gas engine heat pump retrofitted with energy storage unit in heating season, Journal of Tianjin University (Science and Technology), 51, 5, pp. 460-465, (2018)
  • [6] LIU Huanwei, YANG Zhao, WANG Mingtao, Cooling performance of gas engine-driven heat pump system, Journal of Tianjin University, 44, 7, pp. 645-649, (2011)
  • [7] WANG Mingtao, LIU Huanwei, ZHANG Baihao, Theoretical and experimental study on heating performance of gas engine-driven heat pump, CIESC Journal, 66, 10, pp. 3834-3840, (2015)
  • [8] WAN X M, CAI L, YAN J, Et al., Power management strategy for a parallel hybrid-power gas engine heat pump system, Applied Thermal Engineering, 110, pp. 234-243, (2017)
  • [9] TIAN Z Y, LIU F G, TIAN C F, Et al., Experimental investigation on cooling performance and optimal superheat of water source gas engine-driven heat pump system, Applied Thermal Engineering, 178, (2020)
  • [10] WANG Mingtao, YANG Zhao, Simulation on variable capacity controller of heat pump of gas engine, Journal of Tianjin University, 44, 3, pp. 272-276, (2011)
123