Optimized two-dimensional FFT signal processing algorithm for millimeter-wave FM fuze

被引：0
|
作者：
Guo C. [1 ]
Hao X. [1 ]
Li P. [1 ]
Li G. [1 ]
Jia R. [1 ]
机构：
[1] Science and Technology on Electromechanical Dynamic Control Laboratory, Beijing Institute of Technology, Beijing
来源：
Beijing Hangkong Hangtian Daxue Xuebao/Journal of Beijing University of Aeronautics and Astronautics | 2020年 / 46卷 / 01期
基金：
中国国家自然科学基金;
关键词：
Millimeter-wave frequency modulated fuze; Range and velocity joint estimation; Relative distance evaluation function; Signal processing algorithm; Two-dimensional FFT;
D O I：
10.13700/j.bh.1001-5965.2019.0185
中图分类号：
学科分类号：
摘要：
In this paper, a two-dimensional fast Fourier transform(FFT) signal processing algorithm based on relative distance evaluation function optimization is proposed for the joint estimation of target range and velocity information of millimeter-wave frequency modulated fuze. The relationship between the accuracy of the actual ranging and velocity measurement and the number of FFT points is analyzed first. Then an optimization mathematical model is established. The mathematical model is solved by utilizing relative distance evaluation function. After obtaining the optimal solution of the number of FFT points, the beat frequency signal is sampled into two-dimensional data matrix. The corresponding FFT transformation on the rows and columns of the matrix is performed respectively. Finally, the target range and velocity information is estimated by extracting the coordinates of the peak points. The simulation and discussion analysis demonstrate that the proposed algorithm can effectively improve the accuracy of the actual ranging and velocity measurement of the traditional two-dimensional FFT algorithm and meet the real-time requirements. The algorithm can extract the target range and velocity information of millimeter-wave frequency modulated fuze simultaneously. © 2020, Editorial Board of JBUAA. All right reserved.
引用
收藏
页码：220 / 228
页数：8
相关论文
共 16 条
  • [1] Dao X.Y., Gao M., Development status and key technologies of millimeter wave proximity fuze, Aerodynamic Missile Journal, 5, pp. 86-90, (2018)
  • [2] Anghel A., Vasile G., Cacoveanu R., Et al., Short-range wideband FMCW radar for millimetric displacement measurements, IEEE Transactions on Geoscience & Remote Sensing, 52, 9, pp. 5633-5642, (2014)
  • [3] Yuan H.Q., Zhang X.L., Instantaneous frequency estimation of frequency modulated fuze based on WVD, Journal of Naval Aeronautical and Astronautical University, 26, 3, pp. 301-304, (2011)
  • [4] Choi J.H., Jang J.H., Lee J.H., Et al., Implementation of signal processing algorithms for an FMCW radar altimeter, The Journal of Korean Institute of Electromagnetic Engineering and Science, 26, 6, pp. 555-563, (2015)
  • [5] Liang Y., Liu M.L., Zhou Z.G., Signal processing method of radio fuze based on intra-pulse frequency modulation, Journal of Detection & Control, 36, 2, pp. 27-30, (2014)
  • [6] Li X., Signal processing technology of harmonic comparing frequency modulated doppler fuze, pp. 7-9, (2009)
  • [7] Zhao H.C., Fundamentals and Methodology of Radio Fuze, pp. 56-57, (2012)
  • [8] Ralph D.K., A note on the theory of scattering from an irregular surface, IEEE Transactions on Antenna and Propagation, 14, 1, pp. 77-82, (1966)
  • [9] Donald E.B., Rough surface scattering based on the specular point theory, IEEE Transactions on Antenna and Propagation, 16, 4, pp. 449-454, (1968)
  • [10] Edison A.R., Moore R.K., Warner B.D., Radar terrain return measured at near-vertical incidence, IEEE Transactions on Antenna and Propagation, 8, 3, pp. 246-254, (1960)
12