Study on Influence of Solution Temperature on Strengthening Mechanism of Thin-plated Fine-grained 2A97 Al-Li Alloy

被引：0
|
作者：
Niu F. [1 ]
Ma Z. [2 ]
Guo Y. [2 ]
Liu H. [1 ]
机构：
[1] Modern Engineering Training Center, Chang’an University, Xi’an
[2] College of Materials Science and Engineering, Chang’an University, Xi’an
来源：
Hunan Daxue Xuebao/Journal of Hunan University Natural Sciences | 2023年 / 50卷 / 06期
基金：
中国国家自然科学基金; 中央高校基本科研业务费专项资金资助;
关键词：
aluminum alloys; dislocations; metallography; precipitation; solution temperature;
D O I：
10.16339/j.cnki.hdxbzkb.2023302
中图分类号：
学科分类号：
摘要：
The solid solution temperature affects the strengthening mechanism of thin-plate fine-grain 2A97 alloy with a grain size of less than 10 μm. It has been observed that the tensile strength of peak-aging 2A97 alloy obtained at 540 ° C decreases by 40 MPa compared with 510 ℃ for the same solution time. X-ray diffraction，scanning electron microscopy，and transmission electron microscopy were applied to explain this phenomenon quantitatively from the perspective of strengthening mechanisms such as solid solution strengthening，grain boundary strengthening，dislocation strengthening and precipitation strengthening. It was found that the alloy solution-treated at 540 ℃ exhibited significantly grown grains，higher levels of recovery and recrystallization，lower dislocation density and wider grain boundary precipitate free zone than that at 510 ℃，resulting in a decrease in the properties. © 2023 Hunan University. All rights reserved.
引用
收藏
页码：144 / 155
页数：11
相关论文
共 46 条
  • [1] SANDERS T H, STARKE E A．, The effect of slip distribution on the monotonic and cyclic ductility of Al – Li binary alloys［J］, Acta Metallurgica, 30, 5, pp. 927-939, (1982)
  • [2] ZHANG X, The influence of grain structure on the corrosion behaviour of 2A97-T3 Al-Cu-Li alloy［J］, Corrosion Science, 116, pp. 14-21, (2017)
  • [3] JIA L, Microstructural evolution and superplastic deformation mechanisms of as-rolled 2A97 alloy at low-temperature［J］, Materials Science and Engineering, 759, pp. 19-29, (2019)
  • [4] KAUTZ M．, Fatigue and microstructure of ultrafine-grained metals produced by severe plastic deformation［J］, Scripta Materialia, 51, 8, pp. 807-812, (2004)
  • [5] Improvements of fatigue behaviour in 2014 Al alloy by solution heat treating and age-hardening［J］．Materials & Design，2004，25（5, Rare Metals, 40, 1, pp. 439-445, (2021)
  • [6] FLEISCHER R L．, Substitutional solution hardening［J］, Acta Metallurgica, 11, 3, pp. 203-209, (1963)
  • [7] DUAN S Y, The effect of predeformation on the precipitation behavior of AlCuMg（Si）alloys with low Cu/Mg ratios［J］, Journal of Alloys and Compounds, 823, (2020)
  • [8] DONG F, HUANG S Q, Effect of increased stretching deformation at cryogenic temperature on the precipitation behavior and mechanical properties of 2060 Al-Li alloy［J］, Materials Science and Engineering, 834, (2022)
  • [9] DE GEUSER F, Impact of grain microstructure on the heterogeneity of precipitation strengthening in an Al-Li-Cu alloy［J］, Materials Science and Engineering, 627, pp. 51-55, (2015)
  • [10] Coupling of dislocations and precipitates：impact on the mechanical behavior of ultrafine grained Al-Zn-Mg alloys［J］．, Acta Materialia, 103, pp. 153-164, (2016)
12345