RESEARCH ON THE COMPRESSION BEHAVIOR OF SQUARE TUBED REINFORCED CONCRETE SLENDER COLUMN WITH ADDITIONAL GAP

被引：0

作者：

Gan D. ^{[1
]}

Zhou Q.-L. ^{[1
]}

Yan B. ^{[2
]}

Yue M.-Y. ^{[2
]}

机构：

[1] School of Civil Engineering, Chongqing University, Chongqing

[2] School of Highway, Chang’an University, Xi’an

来源：

Gongcheng Lixue/Engineering Mechanics | 2023年 / 40卷 / 09期

关键词：

moment amplification coefficient; slender column; square section; tube gap; tubed steel reinforced concrete;

D O I：

10.6052/j.issn.1000-4750.2022.01.0058

中图分类号：

学科分类号：

摘要：

For a tubed concrete column, the tube gaps are usually arranged at the column ends to avoid the steel tube carrying loads directly. Two type square tubed steel reinforced concrete (TSRC) columns, i.e., a column with two gaps at the column ends and another column with an additional gap at the mid-height, are discussed in this paper. Experimental studies on the compression behavior of TSRC slender columns were conducted to investigate the effects of the width-to-thickness ratio of steel tube and the load eccentricity ratio. The failure modes, the ultimate strengths, and the load to tube stress curves were analyzed. The results indicated that the two type columns shown similar failure modes. The axial strength of column with additional gap at the mid-height was slightly higher than that of column with two gaps, while the eccentric strength of column exhibited opposite tendency. Parametric analysis were carried out based on the precise finite element (FE) models. Based on the test and FE results, the stiffness reduction coefficient to calculate the moment amplification effect was proposed by regression analysis, and the design method of square TSRC column with additional gap at the mid-height under eccentric compression was proposed. © 2023 Tsinghua University. All rights reserved.

引用

页码：161 / 171

页数：10

共 27 条

[1] ZHOU Xuhong, LIU Jiepeng, Performance and design of tubed concrete column, (2010)
[2] JGJ/T 471−2019, Technical standard for steel tube confined concrete structures, (2019)
[3] JGJ 138−2016, Code for design of composite structures, (2016)
[4] ZHOU Tianhua, YU Jipeng, ZHANG Yu, Et al., Experimental investigation on slender steel reinforced concrete columns with monosymmetric cross-shaped steel under eccentric loading, Engineering Mechanics, 38, 4, pp. 111-122, (2021)
[5] ZHANG Shuchen, YANG Yong, XUE Yicong, Et al., Research on seismic performance of partially precast steel reinforced concrete short columns, Engineering Mechanics, 37, 10, pp. 179-191, (2020)
[6] GAUTHAM A, SAHOO D R., Performance of SRC column-RC beam joints under combined axial and cyclic lateral loadings, Engineering Structures, 260, (2022)
[7] ZHOU X H, YAN B, LIU J P., Behavior of square tubed steel reinforced-concrete (SRC) columns under eccentric compression [J], Thin-Walled Structures, 91, pp. 129-138, (2015)
[8] TOMII M, SAKINO K, XIAO Y, Et al., Earthquake resisting hysteretic behavior of reinforced concrete short columns confined by steel tube [C], Proceeding of the international speciality conference on concrete filled steel tubular structures, pp. 119-125, (1985)
[9] GAO Q, LI J H, QIU Z J, Et al., Cyclic loading test for interior precast SRC beam-column joints with and without slab [J], Engineering Structures, 182, pp. 1-12, (2019)
[10] LAI B L, LIEW J Y R, VENKATESHWARAN A, Et al., Assessment of high-strength concrete encased steel composite columns subject to axial compression, Journal of Constructional Steel Research, 164, (2020)

← 1 2 3 →