Identification method of aerodynamic damping based on the genetic algorithm and random decrement technique

被引：0

作者：

Tang L. ^{[1
,2
]}

Zheng C. ^{[1
,3
]}

机构：

[1] Harbin Institute of Technology, School of Civil Engineering, Harbin

[2] Harbin Institute of Technology, School of Civil and Environmental Engineering, Shenzhen

[3] Key Lab of Smart Prevention and Mitigation of Civil Engineering Disasters of Ministry of Industry and Information Technology, Harbin Institute of Technology, Harbin

来源：

Zhendong yu Chongji/Journal of Vibration and Shock | 2023年 / 42卷 / 06期

关键词：

aerodynamic damping identification; genetic algorithm (GA); improved random decrement technique; natural excitation technique; supertall building;

D O I：

10.13465/j.cnki.jvs.2023.06.003

中图分类号：

学科分类号：

摘要：

The random decrement technique (RDT) has been widely utilized in the modal parameter identification of engineering structures due to its advantages of rapid computation and low cost. Aiming at the shortcomings of subjective selection of the truncation amplitude and sample duration in the RDT, bringing large identification error, a genetic algorithm(GA) was adopted to revise the RDT and an improved RDT (GA - RDT) method was proposed. Then the GA - RDT method was applied in the aerodynamic damping ratio identification of an aeroelastic model of a supertall building. Firstly, the free decay curve obtained by the RDT was fitted and then the error was defined. The effects of the cut-off amplitude and sample duration on the optimization target were analyzed and the genetic algorithm was utilized to search the optimal solution of these two parameters. Secondly, based on the tip acceleration time history acquired by the aeroelastic model wind tunnel tests，the aerodynamic damping ratio was identified by combinedly using the GA - RDT and Hilbert - Huang transformation method. Finally, the aerodynamic damping ratio identified by the natural excitation technique (NExT) was regarded as the benchmark, and the identification accuracy based on the GA - RDT method and traditional RDT method were discussed. The results show that, when compared with the aerodynamic damping ratio identified by the NExT method，the corresponding results identified by the GA - RDT method at different wind speeds have an average error of less than 0. 14% in the X, Y and torsional directions respectively, and the identification accuracy is much better than those identified by the traditional RDT method. Therefore, the feasibility of the aerodynamic damping identification method based on the GA - RDT method is verified. © 2023 Chinese Vibration Engineering Society. All rights reserved.

引用

页码：16 / 23

页数：7

共 30 条

[1] XU Shidai, WANG Fengquan, Mode parameter identification of engineering structure based on arma model, Industrial Construction, 37, 5, pp. 20-22, (2007)
[2] III G J, CARNE T G, LAUFER J., The natural excitation technique (NExT) for modal parameter extraction from operating structures, the International Journal of Analytical and Experimental Modal Analysis, 10, 4, pp. 260-277, (1995)
[3] JUANG J N, PAPPA R S., An eigensystem realization algorithm (ERA) for modal parameter identification and model reduction, Journal of Guidance, Control and Dynamics, 8, 5, pp. 620-627, (1985)
[4] OVERSCHEE P V, MOOR B D., Subspace identification for linear systems: Theory-implementation-applications, (1996)
[5] COLE H A., On-line failure detection and damping measurements of aerospace structures by random decrement signature, (1973)
[6] PENG Cheng, ZHANG Limin, Li Yuanhui, Et al., Identification of modal parameters using improved EMD and Random Decrement Method, Noise and Vibration Control, 31, 6, pp. 53-56, (2011)
[7] ZOU Lianghao, LIANG Shuguo, GU Ming, Evaluation of Aerodynamic Damping in Wind-induced Vibration of Tall Buildings by Random Decrement Technology, Journal of Civil Engineering and Management, 20, 1, pp. 30-33, (2003)
[8] HUANG C S., Structural identification from ambient vibration measurement using the multivariate AR model, Journal of Sound and Vibration, 241, 3, pp. 337-359, (2001)
[9] HAN Jianping, LI lin, WANG Hongtao, Et al., Modal parameter identification based on Hilbert-Huang transformand random decrement technique, World Earthquake Engineering, 27, 1, pp. 72-77, (2011)
[10] AREEMIT N, MONTGOMERY M, CHRISTOPOULOS C, Et al., Identification of the dynamic properties of a reinforced concrete coupled shear wall residential high-rise building, Canadian Journal of Civil Engineering, 39, 6, pp. 631-642, (2012)

← 1 2 3 →