Performance research on high temperature CO2 heat pump with supercritical enhanced gas injection

被引：0
|
作者：
Wu, Mengxia [1 ,2 ,3 ,4 ]
Wang, Hanzhi [2 ,3 ,4 ]
Li, Shuaiqi [2 ,3 ,4 ]
Song, Wenji [2 ,3 ,4 ]
Feng, Ziping [1 ,2 ,3 ,4 ]
机构：
[1] School of Engineering Science, University of Science and Technology of China, Hefei,Anhui,230026, China
[2] Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangzhou,Guangdong,510640, China
[3] CAS Key Laboratory of Renewable Energy, Guangzhou,Guangdong,510640, China
[4] Guangdong Provincial Key Laboratory of New and Renewable Energy Research and Development, Guangzhou,Guangdong,510640, China
来源：
Huagong Jinzhan/Chemical Industry and Engineering Progress | 2020年 / 39卷 / 05期
关键词：
Carbon dioxide - Compressibility of gases - Cooling systems - Gas compressors - Heat pump systems - Pumps;
D O I：
10.16085/j.issn.1000-6613.2019-1404
中图分类号：
学科分类号：
摘要：
A novel high temperature CO2 heat pump cycle with supercritical enhanced gas injection was proposed to significantly improve heating performance under high temperature hydronic heating conditions. The numerical model of the high temperature CO2 heat pump system with supercritical gas injection was established, and the performance of the system was analyzed by EES (engineering equation solver) software. The influence of parameters such as evaporation temperature, middle pressure of compressor, gas cooler pressure, etc. on system performance at the high gas cooler outlet temperature was mainly studied. The results indicated that COP of 3.0 can be reached when the gas cooler outlet temperature was as high as 60℃. In comparison to common vapor injection system, the COP improved distinctly. As compared to conventional system without gas injection, the COP increased by 14.8%, 21.2%, 29.2% respectively with gas injection ratio of 0.3, 0.4, 0.5 at the gas cooler outlet temperature of 60℃. The influence of middle pressure and gas cooler pressure on COP have the same variation trend while the effect of gas cooler pressure is more significant. Besides, there exist an optimal gas cooler pressure and middle pressure. The optimal gas cooler pressure and middle pressure are 13.5MPa and 8.5MPa, respectively, when the gas cooler outlet temperature is 60℃ and the gas injection ratio is 0.4. © 2020, Chemical Industry Press. All right reserved.
引用
收藏
页码：1667 / 1673
相关论文
共 50 条
  • [1] Effects of injection parameters on heat extraction performance of supercritical CO2 in enhanced geothermal systems
    Li, Pan
    Wu, Yu
    Liu, Jiang-feng
    Pu, Hai
    Tao, Jing
    Hao, Yang
    Teng, Yi
    Hao, Guan
    ENERGY SCIENCE & ENGINEERING, 2019, 7 (06): : 3076 - 3094
  • [2] Modelling the performance of a transcritical CO2 heat pump for high temperature heating (Reprinted)
    White, SD
    Yarrall, MG
    Cleland, DJ
    Hedley, RA
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2002, 25 (04): : 479 - 486
  • [3] Modeling and performance simulation of a gas cooler for a CO2 heat pump system
    Chang, Young-Soo
    Kim, Min Seok
    HVAC&R RESEARCH, 2007, 13 (03): : 445 - 456
  • [4] Research progress on thermodynamic performance of supercritical CO2 dry gas seal
    Jiang A.
    Ding X.
    Wang S.
    Ding J.
    Li N.
    Huagong Jinzhan/Chemical Industry and Engineering Progress, 2024, 43 (05): : 2354 - 2369
  • [5] Performance evaluation of a gas injection CO2 heat pump according to operating parameters in extreme heating and cooling conditions
    Chung, Hyun Joon
    Baek, Changhyun
    Kang, Hoon
    Kim, Dongwoo
    Kim, Yongchan
    ENERGY, 2018, 154 : 337 - 345
  • [6] Electrical energy storage using a supercritical CO2 heat pump
    Tafur-Escanta, Paul
    Valencia-Chapi, Robert
    Lopez-Guillem, Miguel
    Fierros-Peraza, Olmo
    Munoz-Anton, Javier
    ENERGY REPORTS, 2022, 8 : 502 - 507
  • [7] Modelling of a new thermal compressor for supercritical CO2 heat pump
    Ibsaine, Rabah
    Joffroy, Jean-Marc
    Stouffs, Pascal
    ENERGY, 2016, 117 : 530 - 539
  • [8] Design and Experimental Research of Gas Cooler for CO2 Heat Pump Water Heater
    Liu, Ye Feng
    Gong, Guo Dong
    Chen, Xi
    ADVANCED MANUFACTURING TECHNOLOGY, PTS 1, 2, 2011, 156-157 : 1161 - 1164
  • [9] High-fidelity reservoir simulations of enhanced gas recovery with supercritical CO2
    Patel, Milan J.
    May, Eric F.
    Johns, Michael L.
    ENERGY, 2016, 111 : 548 - 559
  • [10] Experimental study on the performance of a vapor injection high temperature heat pump
    He, Yongning
    Cao, Feng
    Jin, Lei
    Wang, Xiaolin
    Xing, Ziwen
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2015, 60 : 1 - 8
12345