A structural mechanics analysis on a Type IV hydrogen storage tank during refueling and discharging

High-pressure hydrogen gas, as a power generation fuel widely used in transportation, has significantly contributed to the development of hydrogen fuel cell electric vehicles. However, obvious temperature rise and drop during fast refueling and discharging cause serious safety risk to the structural stability of on-board hydrogen storage tank. The American Society of Automotive Engineers SAE J2601 and the international standard ISO 15869 strictly stipulate that the operation temperature range of hydrogen storage tank varies from-40 degrees C to 85 degrees C. In this study, a finite element mechanics model was constructed using ACP and Static Mechanical software to better understand the deformation, stress, strain, and failure modes experienced by a Type IV tank during charging and discharging. Detailed parameters such as ply angle, ply thickness, mesh generation, and boundary conditions, were extensively elucidated. The results indicate that the high temperature and pressure generated during fast fueling of the storage tanks are less likely to cause yield failure of the inner, outer layers and plug, but the stress concentration caused by low temperature and high pressure may lead to the fracture rupture of internal polyethylene materials. Aluminum alloy plug, serving as sealing devices for the tank, are most susceptible to yielding failure under coupled conditions. The mechanical load reaching the yield stress of the plug is approximately 85 MPa with the nominal working temperature of 85 degrees C. Additionally, the maximum stress on the outer layer can be reduced by adjusting the circumferential layer direction from 90 degrees degrees to 70 degrees degrees or by optimizing the orientation of the maximum stress layer increasing it by 110 degrees. degrees . The present study can offer new insights into the dynamic loading behavior of the Type IV tanks during fast charging and discharging, and may provide technical references for optimization design of the tank structures.