Optimizing the microstructure and enhancing the mechanical prsoperties of hypereutectic Al-Si alloys by Mg addition

The impact of Mg on the solidification structure of hypereutectic Al-Si alloys with different Si contents (15 wt% and 18 wt%) was investigated. 3%Mg was added to Al-15Si alloy to modify the phases in the solidification structure for the improvement of mechanical properties, and T6 heat treatment was used to optimize the microstructure and precipitate strengthening phase. The solidification structure was observed by OM and TEM respectively, and the precipitation behavior of each phase was detected through DSC. The results show that the addition of Mg decreased the undercooling of the alloy melt, thus suppressing the precipitation of primary Si phase. Nanoscale beta" precipitates were precipitated in the matrix after T6 heat treatment. This resulted in an increase of 54% and 165% in the UTS and EL of the alloy, reaching 252 MP and 15.1%, respectively. Primary Si crystals were present in two forms in Al-18Si-8Mg alloy: spinel twin and non-twin, while Mg2Si 2 Si always maintained the faceted crystals during the growing process, where only (100) and (111) crystal planes were observed. XRD, SEM and EBSD have been used to prove that Mg2Si 2 Si crystals with different morphologies could become the heterogeneous nuclei of two types of primary Si crystals. The process of nucleation and growth of primary Si with Mg2Si 2 Si as the heterogeneous nuclei was experimentally analyzed and theoretically predicted.