Investigation of thermal performance at forced convection in plate-fin heat sink

Interest in studies on more effective and faster heat dissipation in microelectronic equipment has increased in recent years due to the cooling area and equipment size limitations. This study attempts to focus on the effect of different fin geometry parameters on pure forced convection heat transfer. Total surface areas of plate-fin heat sinks were kept constant and were carried out for ten different heat sinks in these analyses. The Ansys-Fluent 2023 R1 commercial package program was used to perform the thermal and hydrodynamic performance analyses. Three-dimensional turbulent forced convection heat transfer analyses at heat sinks were subjected to fluid flow (500 <= Re <= 3000). The effects of gap between fins, fin thickness, fin height, fin number, and air velocity on the heat transfer and the friction factor were obtained and discussed for heat sinks. It was observed that there was a maximum difference of 0.27% between the maximum temperatures obtained as a result of this analysis and the experimental study results in the literature. Among the ten cases examined (from Case 1 to Case 10), the highest heat transfer coefficient was obtained in Case 2 (number of fins 6, gap between fins 4 mm, fin height 17 mm and fin thickness 2 mm) at Re = 3000. The heat transfer coefficient of Case 2 was 41.29 % higher than the heat transfer coefficient of Case 4 at Re = 3000; though, the friction factor of Case 2 is 55.93 % higher than Case 4. Also, a useful correlation for the heat transfer coefficient was generated for the fin geometric parameters and Reynolds number.