Experimental Testing of Shear Web Panels of Steel Plate Girders Strengthened by Fiber-Reinforced Polymer Composites

Steel plate girders are susceptible to web buckling due to slender web. This phenomenon creates an undesirable failure mode and limits their ultimate load capacity. The use of fiber-reinforced polymer (FRP) composite materials offers a good prospect of strengthening the slender web of plate girders to avoid web buckling. This paper presents the details of experimental testing of steel plate girders with nonrigid end posts. These girders were tested in three-point bending. The end shear panels of the girders were strengthened by glass FRP (GFRP) pultruded section stiffeners or glass fiber fabric composite. GFRP stiffeners were applied either vertically or along the compression diagonal in the shear panel. All strengthened panels failed by web shear buckling associated with a breakdown of the employed strengthening scheme. It was found that the shear capacity of the panel remained unchanged by replacing the steel stiffener with GFRP stiffeners in the end panel. The critical buckling load of the strengthened panels increased up to 44% compared to the unstrengthened panel. The shear capacities of the panels strengthened by the glass fabric composite and diagonal GFRP pultruded section were the highest and similar to each other. Both these panels resisted a 50% larger shear compared to the unstrengthened panel. The positions of the plastic hinges in all tested panels were the same due to the same ratio of panel length and depth of the web.