Kinematic analysis and experimental validation of a tripod parallel continuum manipulator

A tripod is a classical lower mobility parallel manipulator with three degrees of freedom. The usual geometrical constraints enforce a type of motion with two rotations on a horizontal plane and a translational motion in a vertical direction. These devices are applicable where a task requires a precise orientational motion. Nevertheless, some parasitic motions occur on the constrained degrees of freedom. Parallel Continuum Manipulators are devices where some elements have been replaced by slender rods whose deformation is source of mobility, allowing the elimination of some of the kinematic joints. This type of closed-loop compliant mechanisms have some features that can be useful in certain applications, e.g., the deformed state introduces a certain preload that avoids backslash, they have an inherent compliance that can be useful in some delicate tasks, and a certain control on wrench applied can be obtained. In this article, the comprehensive kinetostatic analysis of a tripod-type parallel continuum manipulator, 3P<overline>FS, is explained and compared with that of its rigid counterpart 3P<overline>RS. Workspace and singularity locus is obtained, positioning accuracy and wrench generation are evaluated experimentally.