Experimental and Numerical Study of Newly Assembled Lightweight Radiant Floor Heating System

In this study, the heating capacity of a new prefabricated assembled hot water radiant modular heating system made from a recycled waste building masonry structure is investigated through experimental and numerical simulation methods. The heating capacity of the system in different working conditions (a water supply temperature of 48 degrees C, 51 degrees C, 56 degrees C, and 61 degrees C; a flow rate of 0.49 m3/h, 0.35 m3/h, and 0.21 m3/h) is analyzed and verified. A three-dimensional steady-state heat transfer numerical model of the floor heat transfer of the module is established, and the accuracy of the model is verified through the measured results to investigate the heating capacity of this system under different water supply temperatures, flow rates and coil spacings. The results show that the new prefabricated hot water radiant module heating system has a 0.9 degrees C higher air temperature and 2.1 degrees C higher average floor surface temperature than the traditional wet floor radiant heating system under the same experimental conditions, and the response time is 44% shorter. The water supply temperature can significantly change the heating capacity of the system, while the water supply flow rate has little effect on the system. The established three-dimensional steady-state numerical model can be in good agreement with the measured results. This study can provide an experimental and theoretical basis for the design and application of such systems.