Structure and Mechanical Properties of WC-Based Hardmetal with a High-Entropy NiFeCrWMo Binder

An equiatomic NiFeCrWMo high-entropy alloy (HEA) produced by mechanical alloying was used as a binder alternative to cobalt for the manufacture of WC-based hardmetals. The WC-10 HEA (wt.%) powder mixture was homogenized in a planetary-ball mill for 2 h and consolidated by electron beam sintering (EBS) for 4 min at a temperature of 1450 degrees C and spark plasma sintering (SPS) for 10 min at a temperature of 1400 degrees C. The relative density of the sintered samples reached 99.4%. The phase composition, microstructure, and mechanical properties of WC-10 HEA hardmetals were studied by X-ray diffraction, scanning electron microscopy, and microindentation. The effect of the NiFeCrWMo HEA binder on the microstructure and mechanical properties of WC-10 HEA hardmetals in comparison with the conventional VK8 hardmetal (WC-8 Co) was determined. The WC-10 HEA hardmetal consolidated by EBS consisted of WC grains, a NiFeCrWMo HEA binder with a bcc structure, and a small amount (3.5%) of complex carbide (Ni, Fe, Cr)xWyCz, whereas the amount of the complex carbide after SPS increased to 47% due to longer sintering and pressure application. No noticeable growth of WC grains was observed during sintering of the WC-10 HEA hardmetal because of the multielement composition of the NiFeCrWMo HEA binder and the formation of complex carbide (Ni, Fe, Cr)xWyCz layers, preventing the growth of WC grains. The hardness HV and fracture toughness KIc of WC-10 HEA hardmetals after EBS were 18.9 GPa and 11.4 MPa <middle dot> m1/2 and those after SPS were 19.9 GPa and 10.8 MPa <middle dot> m1/2. The hardmetals with a HEA binder exhibit an excellent combination of hardness and fracture toughness. These values are higher than those for the conventional VK8 hardmetal (WC-8 Co) produced by EBS for 4 min at 1350 degrees C, whose hardness is 16.5 GPa and fracture toughness KIc is 9.5 MPa <middle dot> m1/2.