INFLUENCE OF ROLLING MODES ON THE ANISOTROPY OF SHEET METALS FROM CARBON STEEL ROLLED ON THE LONGITUDINAL WEDGE MILL (LWM) OF A NEW DESIGN

被引：0

作者：

Mashekov, S. A. ^{[1
]}

Tussupkaliyeva, E. A. ^{[1
]}

Akparova, S. A. ^{[1
]}

Kiyanbekova, L. R. ^{[1
]}

Nurakhmetova, K. K. ^{[1
]}

Absadykov, B. N. ^{[2
]}

机构：

[1] Satbayev Univ, Alma Ata, Kazakhstan

[2] AB Bekturov Inst Chem Sci, Alma Ata, Kazakhstan

来源：

METALURGIJA | 2021年 / 60卷 / 1-2期

关键词：

steel S235JR; LWM; sheet; stress-strained state; temperature-deformation processing;

D O I：

暂无

中图分类号：

TF [冶金工业];

学科分类号：

0806 ;

摘要：

The longitudinal wedge mill (LWM) of a new design is proposed in this article. By using the MSC.SuperForge software product which designed for the stress-strained state of the billet when rolling strips from steel S235JR on the LWM. The STD 812 plastometer analyzed the influence of temperature-deformation processing modes on the microstructure of S235JR steel which rolled on LWM, the conditions for the formation of a fine-grained structure were noted. The rational modes of hot and cold rolling and their effect on the anisotropy of sheet metals from steel S235JR have been defined. It was proved in our work that compared with cold rolling, during hot rolling of sheet billets in the sheet plane it does not appear the significant anisotropy of mechanical properties.

引用

页码：125 / 128

页数：4

共 5 条

[1] THE INFLUENCE OF TEXTURE INHOMOGENEITIES ON THE PLASTIC ANISOTROPY OF HOT-ROLLED LOW-CARBON SHEET STEEL
WELCH, PI
BUNGE, HJ
VLAD, CM
[J]. ARCHIV FUR DAS EISENHUTTENWESEN, 1984, 55 (07): : 321 - 324
[2] Influence of cold rolling reduction and grain refinement of hot bands on planer anisotropy of r-value of cold rolled extra low carbon steel sheets
Senuma, T
Kameda, M
[J]. TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1996, 82 (10): : 72 - 77
[3] Improvement of Technology for Producing Rolled Sheet from Continuously Cast Steel Slabs. Part 2. Physical Modeling of Low-Carbon Steel Strip Rolling*
A. V. Aldunin
V. V. Stulov
[J]. Metallurgist, 2021, 64 : 912 - 916
[4] Improvement of Technology for Producing Rolled Sheet from Continuously Cast Steel Slabs. Part 2. Physical Modeling of Low-Carbon Steel Strip Rolling*
Aldunin, A., V
Stulov, V. V.
[J]. METALLURGIST, 2021, 64 (9-10) : 912 - 916
[5] Influence of grain refinement of hot band and cold rolling reduction on planar anisotropy of R-value of cold rolled plain extra low carbon steel sheets
Senuma, T
Suehiro, M
[J]. THERMEC '97 - INTERNATIONAL CONFERENCE ON THERMOMECHANICAL PROCESSING OF STEELS AND OTHER MATERIALS, VOLS I-II, 1997, : 2335 - 2341

← 1 →