Three-dimensional inversion of knot defects recognition in timber cutting

The comprehensive utilization of wood is the main goal of log cutting,but knot defects increase the difficulty of rationally optimizing cutting.Due to the lack of real shape data of knot defects in logs,it is difficult for detection methods to establish a correlation between signal and defect morphology.An image-processing method is proposed for knot inversion based on distance regularized level set segmentation(DRLSE) and spatial vertex clustering,and with the inversion of the defects existing relative board position in the log,an inversion model of the knot defect is established.First,the defect edges of the top and bottom images of the boards are extracted by DRLSE and ellipse fitting,and the major axes of the ellipses made coplanar by angle correction;second,the coordinate points of the top and bottom ellipse edges are extracted to form a spatial straight line;third,to solve the intersection dispersion of spatial straight lines and the major axis plane,K-medoids clustering is used to locate the vertex.Finally,with the vertex and the large ellipse,a 3D cone model is constructed which can be used to invert the shape of knots in the board.The experiment was conducted on ten defective larch boards,and the experimental results showed that this method can accurately invert the shapes of defects in solid wood boards with the advantages of low cost and easy operation.