THE INFLUENCE OF THE INJECTION SYSTEM ON DRAG REDUCTION

The influence of the injection system for centerline injected polymer solutions (threads) on drag reduction in a turbulent pipe flow was studied using injectors of different length and grids. Compared with a short injector, the long injector showed a different behavior: the drag reduction was lower and its onset point was shifted to higher Reynolds numbers. The velocity profiles for the polymer-phase and the water-phase were measured simultaneously with a combination of laser-Doppler-velocimetry LDV and laser-induced fluorescence LIF. It was found that the analysis of the LDV-measurements with respect to the difference in velocity between the polymer-phase and the water-phase can give information about the mixing between both phases. For a Reynolds number of 30000 the difference between the phases is comparatively large for low drag reduction and very small for high drag reduction. The results indicate that the drag reduction achieved by injecting a concentrated polymer solution is mainly caused by a mixing process between polymer and water.