THE CHARACTERISTICS OF PULSED HOLLOW-CATHODE DISCHARGES USED FOR PSEUDOSPARK SWITCH TRIGGERING

The complex interaction between trigger discharge and main switch discharge in high-power gas discharge switches influences both, the switching characteristics, and the switch and trigger lifetime. Any attempts to improve either of these parameters has to take into account the pressure and geometry dependence of a particular trigger geometry. Yet, although not very intensely investigated in detail for this particular purpose, pulsed hollow cathode discharges are commonly used for low-pressure gas discharge triggering like in pseudospark switches. Measurements of the electron current flowing to the cathode backplane of a pseudospark switch from the pulsed hollow cathode trigger discharge show, that maximum current densities are peaked around the symmetry axis of the trigger electrode, an effect which is more pronounced at low pressures. Delayed (and slowed-down) increase of the current density at larger radii leads to increasing delay and jitter, provided the trigger coupling holes in the cathode backplane are located off-axis. The electron current density increases with decreasing diameter of the trigger electrode, and with increasing pressure of the working gas. In addition, it is shown that a preionization (keep-alive) current in the trigger electrode region shows a distinct influence on the trigger current distribution, proofing that there exists an optimum keep-alive current depending on geometry and gas pressure.