COMPARISON BETWEEN EXTRACTION OF LIPIDS AND FATTY-ACIDS FROM MICROALGAL BIOMASS

Seven solvent mixtures have been used to extract the lipid fraction of lyophilized biomass of Isochrysis galbana. Six of them were composed of biocompatible solvents. Each method was carried out under relaxed operating conditions (i.e., one hour at room temperature) with extraction in a nitrogen atmosphere to prevent autooxidation and degradation of polyunsaturated fatty acids (PUFAs). Apart from the well-established Bligh and Dyer method [Can. J. Biochem. Physiol 37:911 (1959)] (Cl3CH/MeOH/H2O, 1:2:0.8, vol/vol/vol), which rendered the highest yield of lipids (93.8%), ethanol (96%) and hexanelethanol (96%), 1:2.5 vo/vol produced the best results (84.4 and 79.6%, respectively). To obtain free fatty acids, KOB was added to the solvent mixtures used to extract the total lipids, except for Cl3CH/MeOH/H2O, and direct saponification was carried out at 60 degrees C for 1 h or at room temperature for 8 h. The highest yields obtained by direct saponification were 81% with hexanelethanol (96%), 1:2.5, vol/vol and 79.8% with ethanol (96%). Partial yields of the main n-3 PUFAs found in I. galbana, stearidonic acid (SA), eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA), were calculated for both extraction methods. For lipid extraction with ethanol (96%), yields of 91, 82 and 83% were obtained for SA, EPA and DHA, respectively. When direct saponification was used, hexanelethanol (96%; 1:2.5, vol/vol) produced the best yields of (91, 79 and 69% for SA, EPA and DHA, respectively).